Friction reducers are one of the most widely used additives in slickwater fracturing. In this article we cover what they are, how they work, the main types, and why picking the right one for your water matters.
- Friction reducers lower pumping pressure by reducing turbulence in the pipe.
- The right friction reducer depends largely on your water chemistry.
- Lower friction pressure means lower fuel costs, less wear on equipment, and more room to pump at higher rates.
Introduction
Friction reducers are a standard part of slickwater fracturing, and they have a direct effect on pump pressure, fuel use, and how much wear and tear is placed on pumping equipment. This article covers what they are, how they work, and why the water on location usually decides which one to run.
What is a Friction Reducer?
A friction reducer is a chemical additive, usually a long chain polymer, added to fracturing fluid to reduce the pressure lost to friction as the fluid is pumped down the wellbore. Hydraulic fracturing involves pumping large volumes of fluid and proppant at high rates and pressures to create fractures in the rock, allowing oil or gas to flow more freely. At those rates, the flow in the pipe is highly turbulent, and a large share of the pump pressure is lost to friction before it ever reaches the formation. That means more horsepower, more fuel and more wear on equipment.
How Do Friction Reducers Work?
Friction reducers are typically high molecular weight polyacrylamide based polymers, supplied as an emulsion, a slurry, or a dry powder, that hydrate in the water based fracturing fluid. Once hydrated, the long polymer chains stretch out in the flow and dampen the turbulent eddies that form near the pipe wall. Less turbulence means less energy lost to friction, so the same rate can be pumped at a lower pressure, or a higher rate at the same pressure.
By lowering the required pressure, friction reducers:
- Decrease the horsepower and fuel needed for pumping
- Reduce wear and tear on pumps and surface iron
- Allow higher pump rates within surface pressure limits
- Leave more pressure available at the perforations to create and grow fractures
Types of Friction Reducers
The choice of friction reducer depends on the well and, most of all, on the water being used. The most common types include:
- Anionic polymers: The most widely used, performing well in fresh and low salinity water. They can lose performance in the presence of hardness and iron.
- Cationic polymers: Better suited to high salinity water and brines, where anionic polymers may struggle.
- Net-nonionic or zwitterionic polymers: A mix of charges, so they hold up across a wider salinity range than a straight anionic or cationic.
With more produced and recycled water on location, the useful test is the FR in that water, not in 2% KCl from the lab.
Benefits of Friction Reducers
- Improved efficiency: The same or better results with less horsepower and fuel.
- Cost savings: Lower fuel and power costs, and fewer repairs and replacements.
- Extended equipment life: Less strain on pumps and iron lowers maintenance costs.
- Better rate and pressure management: More of the available pressure goes into the fracture instead of being lost in the pipe.
- Environmental benefits: Less fuel burned means lower emissions per stage.
Wrapping It Up
Pick the FR for the water you are actually pumping. An anionic that looks fine in fresh water can fall over once hardness or iron shows up, and that does not show on a generic data sheet. Test it in source water before the job, not after the pressure is already high.
More on FR selection and fluid testing in upcoming posts.


