Fracturing Chemistry

Friction Reducers: A Key Component in Hydraulic Fracturing

By PureChem Frac Technical Team 3 min read
Collage of friction reducer chemistry: red turbulent flow patterns, rippled sand, a technician at laboratory test equipment, underwater light rays, red fluid droplets and fractured rock with an electric discharge

Friction reducers are one of the most widely used additives in slickwater fracturing. In this article we cover what they are, how they work, the main types, and why picking the right one for your water matters.

Key Takeaways
  • Friction reducers lower pumping pressure by reducing turbulence in the pipe.
  • The right friction reducer depends largely on your water chemistry.
  • Lower friction pressure means lower fuel costs, less wear on equipment, and more room to pump at higher rates.

Introduction

Friction reducers are a standard part of slickwater fracturing, and they have a direct effect on pump pressure, fuel use, and how much wear and tear is placed on pumping equipment. This article covers what they are, how they work, and why the water on location usually decides which one to run.

What is a Friction Reducer?

A friction reducer is a chemical additive, usually a long chain polymer, added to fracturing fluid to reduce the pressure lost to friction as the fluid is pumped down the wellbore. Hydraulic fracturing involves pumping large volumes of fluid and proppant at high rates and pressures to create fractures in the rock, allowing oil or gas to flow more freely. At those rates, the flow in the pipe is highly turbulent, and a large share of the pump pressure is lost to friction before it ever reaches the formation. That means more horsepower, more fuel and more wear on equipment.

How Do Friction Reducers Work?

Friction reducers are typically high molecular weight polyacrylamide based polymers, supplied as an emulsion, a slurry, or a dry powder, that hydrate in the water based fracturing fluid. Once hydrated, the long polymer chains stretch out in the flow and dampen the turbulent eddies that form near the pipe wall. Less turbulence means less energy lost to friction, so the same rate can be pumped at a lower pressure, or a higher rate at the same pressure.

By lowering the required pressure, friction reducers:

Types of Friction Reducers

The choice of friction reducer depends on the well and, most of all, on the water being used. The most common types include:

With more produced and recycled water on location, the useful test is the FR in that water, not in 2% KCl from the lab.

Benefits of Friction Reducers

Wrapping It Up

Pick the FR for the water you are actually pumping. An anionic that looks fine in fresh water can fall over once hardness or iron shows up, and that does not show on a generic data sheet. Test it in source water before the job, not after the pressure is already high.

More on FR selection and fluid testing in upcoming posts.

Have a Technical Challenge
We Haven't Covered?

Our team works directly with operators across the WCSB. If you are dealing with a specific formation challenge, fluid compatibility issue, or completions question, we want to hear it.

Talk to Our Technical Team